SecurityMan DVR-04 Guide d'installation télécharger pdf (Page 59)

Chapter 3: First-Time NT500 Offline System Installation & Setup

3 – 41

NotesTo identify and configure a lock

To identify and configure a lock the laptop must be connected

properly to the lock. The Stanley NT500 Software is used to

choose the appropriate controller information to transfer.

1 From the Explorer Bar’s Navigator tab, click the Hardware

icon.

2 Under Connected Controllers, highlight the controller you

want to configure.

3 Identify the controller:

a) On the Details tab, click Tasks, then Identify Controller…

The Identify/Configure Controller window appears.

b) In the COM Port field, select the appropriate COM port.

c) Click Identify.

A message appears stating, "Please check the connection

or wake the controller."

d) Swipe a temporary operator card to activate the lock.

The diagnostic information for the lock appears.

4 Click Configure.

A message appears stating, "Connect 'Controller Name'

with 'Serial Number'?"

5 Click OK.

The controller is now configured with the diagnostic informa-

tion from the lock.

To transfer controller settings to a lock

When a connection is made to the controller to allow transfer-

ring controller settings, events will be automatically updated

first. Then the task of transferring settings can be selected.

1 Make sure the laptop is connected to the lock.

2 From the Explorer Bar’s Navigator tab, click the Hardware

icon.

3 Under Connected Controllers, highlight the controller with

the settings you want to transfer to the lock.

4 Connect to the controller:

a) Click Tasks, then Connect to Controller.

The Connect to Controller window appears.

b) In the COM Port field, select the appropriate COM port.

c) Click Connect.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 73 74

Pas de commentaire

SecurityMan DVR-04 Guide d'installation Page 59