SecurityMan LCDDVR4 Manuel d'utilisateur télécharger pdf (Page 21)

HARDWARE SETUP

Hard Drive Installation

To install a SATA hard drive into the LCDDVR, please remove the four screws

from the HDD bracket located in the back panel of the DVR (Step 1). Setup

the jumper setting on the SATA hard drive to either 1.5Gb/s or 3Gb/s operation,

prefer to set to 3Gb/s (Step 2). Secure the hard drive to the HDD bracket with

the provided HDD screws (4x). Then connect the Power and Data cable of the

DVR to the SATA hard drive (Step 3). Slips the HDD bracket back into its slot

and secure the bracket with the four screws (blk), as shown below in step 4

and step 5.

External Monitor Installation

Connect the VIDEO OUT (BNC) from the DVR to the video input of an external

monitor for larger screen display or if the built-in LCD monitor fail.

Step 1 Step 2 Step 3

Step 4

Step 5

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 77 78

Pas de commentaire

SecurityMan LCDDVR4 Manuel d'utilisateur Page 21