SecurityMan PIR-SD Manuel d'utilisateur télécharger pdf (Page 17)

Motion

Record

Stop

Record

Emergency

Record

Operation

Using PIR-SD

Motion Detection Recording

To Activate Motion Detection recording, simply

press any of the “Motion Record” buttons on

the remote control and the PIR-SD will beep

once to indicate that motion detection has been

activated in stand-by mode. Once activated and

motion has been detected after the 8 seconds

delay time to exit, the red LED will ﬂash continuously

to indicate recording. The PIR-SD will record a

1 minute video clip per motion detection event.

Note: The PIR-SD has a built in 8 second exit delay that allows the

user to exit the detecting area (after activating motion detection)

without triggering the PIR to record.

Emergency Recording

Press the “Emergency Record” button on the

remote control (at any time) to start an

immediate Emergency recording event. Once

activated, the red LED will become solid

(while recording) and the PIR-SD will record a

1 minute video clip per emergency recording event.

Stop Recording

To stop emergency recording or Deactivate

Motion Detection recording, simply press

the “Stop Record” button on the remote

control at any time (the PIR-SD will beep twice

to indicate that recording has been stopped).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23

Pas de commentaire

SecurityMan PIR-SD Manuel d'utilisateur Page 17