SecurityMan PIR-SD Manuel d'utilisateur télécharger pdf (Page 21)

the PIR-SD will beep 5 times to indicate video recording has

been successfully enabled. PIR-SD will beep 2 times to

indicate failure; please repeat steps 1-2 above.

IMPORTANT NOTICE: Enabling video recording when integrating

with SM-8808T or SM-8808E Air-Alarm Hosts will have a 2-sec or

3-sec delay time to record respectively due to processing speed.

Please note that it is normal for the PIR-SD to have a 2~3-sec delay

time to record, so it is important and a recommendation to mount

the PIR-SD 15ft from the intended target for proper monitoring view

and proper recording ﬁle.

Note: Study mode will automatically turned oﬀ if inactive for more

than 20 seconds.

Disabling Video Recording

Make sure the host is “DIS-ARMED” and press:

Press and hold down the “Study Button” on the back of the PIR-SD for

5 seconds, and the PIR-SD will beep for 3 seconds to indicate video

recording is successfully disabled.

NOTE: Since the same command are use to remove the remote

control from the PIR-SD and the same command use to disable video

recording from the Alarm Host, it is important to remember to Study/

pair the remote control back to the PIR-SD whenever disabling video

recording from the Alarm Host.

After the PIR-SD has been successfully added to the Alarm Host series,

the PIR-SD should function similar to that of the standard motion

detection sensor. If the PIR-SD is triggered by motion in Armed mode, it

will alert the Alarm Host to alarm and at the same time the Alarm Host

will send a signal to the PIR-SD recorder to start the video recording

process. Moreover, if any of the input sensing device(s) that are pre-

programmed to the Alarm Host triggered at anytime to alert the Alarm

1 2 ... 16 17 18 19 20 21 22 23

Pas de commentaire

SecurityMan PIR-SD Manuel d'utilisateur Page 21